Setting Video Parameters
SUMMARY STEPS
1.
2.
3.
4.
5.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
call-manager-fallback
Example:
Router(config)# call-manager-fallback
Step 4
video
Example:
Router(config-call-manager-fallback)# video
Step 5
maximum bit-rate value
Example:
Router(conf-cm-fallback-video)# maximum
bit-rate 256
Examples
The following example shows the configuration for video with Cisco Unified SRST:
call-manager-fallback
max-conferences 2 gain -6
transfer-system full-consult
ip source-address 10.0.1.1 port 2000
max-ephones 52
max-dn 110
dialplan-pattern 1 4084442... extension-length 4
transfer-pattern .T
keepalive 45
voicemail 6001
call-forward pattern .T
call-forward busy 6001
OL-13143-04
enable
configure terminal
call-manager-fallback
video
maximum bit-rate value
video
maximum bit-rate 384
How to Set Video Parameters for Cisco Unified SRST
Purpose
Enables privileged EXEC mode.
•
Enter your password if prompted.
Enters global configuration mode.
Enters call-manager-fallback configuration mode.
Enters call-manager-fallback video configuration mode.
Sets the maximum IP phone video bandwidth, in kbps. The
range is 0 to 10000000. The default is 10000000.
Cisco Unified SCCP and SIP SRST System Administrator Guide
269