Yamaha DME Designer Owner's Manual page 345

Section
4
Equalizer Bypass
5
Gain
6
GEQ ON
7
Range (Button)
8
EQ Flat
9
Input Level
)
Phase
!
HPF Frequency
@
Bypass
#
LPF Frequency
$
Bypass
%
Notch Frequency
^
Q:
&
Bypass
*
Output Level
(
On
EQ Graph [Bypass] Button
A number for each frequency band is displayed on these buttons. When you click the button, it
lights up and the bypass turns ON. When you turn this ON, bypassed sound (unchanged sound) is
output. When you turn this OFF, the sound is output with effects applied.
Parameter Setting Range
ON/OFF
Set by [Range].
ON/OFF
±15
±12
±6
-24
--
- to +10 dB
ON/OFF
20 Hz to 20 kHz
ON/OFF
20 Hz to 20 kHz
ON/OFF
20 Hz to 20 kHz
0.1 to 63.0
ON/OFF
- to ±0 dB
ON/OFF
Bypass ON
Chapter 6 Component Guide
Function
Bypasses all bands in the GEQ equalizer
section.
Sets the output gain for its band.
Turns the GEQ ON.
Selects the gain adjust width.
Returns the faders of all bands to 0dB.
Sets the input signal level.
Reverses the phase of the input signal.
Sets the HPF cutoff frequency.
Turns bypass ON.
Sets the LPF cutoff frequency.
Turns bypass ON.
Sets the notch filter frequency.
Sets the width of the frequency band that will
be changed by the filter.
Turns bypass ON.
Sets the signal level.
Turns output ON.
Bypass OFF
DME Designer Owner's Manual 345