Yamaha DME Designer Owner's Manual page 416

Chapter 6 Component Guide
MY16-C
Double-click the block to display the component editor for it.
1
2
3
4
5
NOTE
The parameters will not link immediately when Setting Priority is switched.
Please edit another parameter after switching Setting Priority.
416 DME Designer Owner's Manual
1
2
3
4
5
Section Parameter
Setting Priority Setting Priority
Bundle Number Input
Output
Serial Channel Rx
Tx
Properties Bit Length
Latency
MY16-C component editor
MY16-C R | [ l g G f B ^ [
Setting Range
Hardware/ The MY16-C switch settings take priority when
Software "Hardware" is selected, and the DME Designer
settings take priority when "Software" is
selected.
0 to 65279 Sets the input bundle number.
0 to 65279 Sets the output bundle number.
OFF, 1 - 16 Sets the serial channel for the receive side.
OFF, 1 - 16 Sets the serial channel for the send side.
Bit Off Sets the bit rate for output. Mutes the signal if
16 bit [Bit Off] is set.
20 bit
24 bit
5.33 ms Sets the delay.
2.67 ms
1.33 ms
Function