Chapter 6 Component Guide
High Pass Filter (HPF)
The high pass filter passes frequencies in the signal that are higher than a specified frequency, while
attenuating lower frequencies in the signal. There are two types of HPF components: mono channel
and stereo channel. Mono channel HPFs have one input and one output. Stereo channel HPFs have
two of each.
Double-click a component to display the component editor for it. The parameters are the same for
mono channel and stereo channel components.
1
2
3
4
5
6
350
DME Designer Owner's Manual
Section
Parameter
Input
Level
Phase
HPF
Frequency
Slope
Bypass
Output
Level
HPF component editor
1
3
4
6
2
5
Setting Range
- to +10 dB
Sets the input signal level.
ON/OFF
Reverses the phase of the input signal.
20 Hz to 20 kHz
Sets the cutoff frequency.
6 dB/Oct
Sets the attenuation for each octave.
12 dB/Oct
ON/OFF
Turns bypass ON.
- to ±0 dB
Sets the output signal level.
Function