SOFTWARE. • You may permanently transfer to a third party all your rights in the SOFTWARE, provided that you do not retain any copies and the recipient reads and agrees to the terms of this Agreement.
This Agreement shall be interpreted according to and governed by Japanese law without reference to principles of conﬂict of laws. Any dispute or procedure shall be heard before the Tokyo District Court in Japan. If for any reason a court of competent jurisdiction ﬁnds any portion of this Agreement to be unenforceable, the remainder of this Agreement shall continue in full force and effect.
Ethernet cable. Connection of computer and the DSP5D Connect the computer to the DSP5D by using an Ethernet cable via a network switch. When you connect the computer to the DSP5D directly, you can use either a crossover or straight cable.
Click [Remove] for the DME-N Network Driver. Follow the onscreen instructions to uninstall the driver. If you attempt to reinstall the software after uninstalling it without ﬁrst restarting your computer, the following message will appear and the install process will be aborted.
When running under Windows Vista / 7, the “User Account Control” dialog box may appear. Click [Continue]. If an application that uses the DME-N Network Driver is running at this time the “Quit all applications that use the DME-N Network Driver in order to change settings.”...
[New] Button Click this button to add a new device to the list. Edit the device’s parameters as required via the ﬁelds in the device information area (2) below the list, then click the [Apply] button to add the speciﬁed device.
Device Port No. The MIDI port number of the device selected in the Target Device List can be set via this menu. The MIDI port number also functions as device ID number. It should be set to “1” for DSP5D.
Network Driver” dialog box. In order to search the MAC address, the IP addresses of the DSP5D and the computer must have been assigned properly. For the default value of IP address, refer to “Connect the DSP5D to your computer via Ethernet” of the DSP5D owner’s manual.
) [Export Setup to File] Button It is possible to save the setup data to a ﬁle that can then be reloaded when working in a different environment. Click to open the “Saves the current ﬁle with a new name” dialog box.
Enter your computer’s IP address into [IP address], the Gateway’s IP address into [Default gateway], and “255.255.255.0” into [Subnet mask]. When installing on the same subnet as the DME unit(s), set the gateway’s host address to 254. Click [OK]. Restart your computer.
Enter your computer’s IP address into [IP address], the Gateway’s IP address into [Default gateway], and “255.255.255.0” into [Subnet mask]. When installing on the same subnet as the DME unit(s), set the gateway’s host address to 254. DME-N Network Driver Installation Guide for DSP5D...
• Did you enter an appropriate IP address of the DSP5D? The IP address of the DSP5D can be checked in the PREFERENCE 2 screen on the PM5D console if the DSP5D is cascade- connected to the PM5D. If the DSP5D is used alone, refer to “Connect the DSP5D to your computer via Ethernet” of the DSP5D owner’s manual and “Console Setup”...
[Firewall]. If using other security software: Either set the security software to allow use of TCP port 12300 on the network card being used by the DME-N Network Driver, or disable the security software. U.R.G., Pro Audio & Digital Musical Instrument Division, Yamaha Corporation ©...