Status Bar - Yamaha DME Designer Owner's Manual

[Zoom Out]/[Zoom In]/[Actual Size]/[Zoom To] Buttons
These buttons correspond to the commands on the [View] menu with the same names. Changes
the magnification of the display on the screen.
"[View] Menu" in "Designer Window Menus"

Status Bar

DME ID/Component ID
DME ID/Component ID
When the mouse pointer is moved over a DME device in the Zone window, the ID for that DME
device is displayed. When the mouse pointer is moved over a component in the Configuration
window, the ID for the component is displayed.
Sheet size
Displays the size of the sheet in the active design window.
Coordinates
Displays the coordinates of the mouse pointer any time it is within the design window. When
dragging an object, the coordinates displayed here refer to the upper left corner of the object
being dragged.
Resource Meter Window
The Resource Meter window is displayed only when the Configuration window and User Module
window are active. Meters for the DSP memory usage percentage and the SPX resource usage
percentage are in the Resource Meter window.
DSP Memory Usage Percentage
When you are designing in the Configuration window, it gives you a yardstick for judging the total
usage percentage for DSP memory in the DME unit. You cannot create a design that exceeds 100
percent usage in a single configuration window. In addition, the usage percentage varies
depending on the sampling frequency, even for the same component.
When the configuration is synchronized with the DME unit during online status, checks of
connections and component information begin automatically (this is called compiling). The actual
total usage percentage is calculated after this compiling operation. The usage percentage will vary
according to the number of connections and components. The Resource Meter window gives you
a precompile guideline for use while designing your configuration. An error may occur even when
the meter shows less than 100 percent, based on conditions such as the number of connections,
and type and number of components used.
NOTE
If a configuration is compiled at fs=44.1kHz or 48kHz, and the sampling frequency is then changed to 88.2kHz or 96kHz, it is
necessary to recompile at 88.2kHz or 96kHz. If this is not done some configurations may produce no sound. In such cases a
"DSP Power Shortage" message will be displayed on the DME unit.
(page 147)
Sheet Size
Chapter 4 Designer
Coordinates
DME Designer Owner's Manual 139