Yamaha DME Designer Owner's Manual page 338

Chapter 6 Component Guide
Double-click a component to open the component editor for it. The parameters are the same for mono
channel and stereo channel components.
1
2
3
4
5
6
7
8
9
)
!
338 DME Designer Owner's Manual
De-Esser component editor
1
Name
De-Esser Curve
Gain Reduction Meter
Output Meter
Parameter Setting Range
Threshold -54 dB to ±0 dB
Ratio 1:1 to :1
Knee HARD, 1, 2, 3, 4, 5
Attack 0 to 120 ms
Release 44.1 kHz: 6 ms to 46 s
48 kHz: 5 ms to 42.3 s
88.2 kHz: 3 ms to 23 s
96 kHz: 3 ms to 21.1 s
Gain ±0 dB to +18 dB
Frequency 80 Hz to 10 kHz
On ON/OFF
4
7 8
2 3
Displays results graphically. The horizontal axis is the
input signal level, and the vertical axis is the output
level.
Displays the gain reduction attenuation.
Displays the output signal level.
Sets the threshold value.
Sets the compression ratio.
Sets the way the de-esser effect is applied.
Sets the attack time.
Sets the release time.
The setting range may very, depending on the
operating frequency.
Sets the output gain.
Sets the minimum signal frequency for compression.
Turns the de-esser ON.
+20
+10
Ratio= 2 : 1
0
–10
Knee = Hard
–20
–30
–40
–50
Threshold= –20dB
–60
–70
–70 –60 –50 –40 –30 –20 –10 0 +10 +20
Input Level (dB)
5 6
9 )
9
Function
Function