Cleaning And Disinfection; Cleaning The Device - Infors HT MULTITRON STANDARD Operating Manual

8.2

Cleaning and Disinfection

8.2.1

Cleaning the Device

Detergent
Notices on Cleaning
Spray
29.11.2024
If substances, especially substances hazardous to health, have been
spilled on or in the device, the device must be thoroughly cleaned
and disinfected. The device should also be routinely cleaned and disin-
fected at regular intervals to ensure trouble-free operation.
If you are not sure about the compatibility of cleaning agents and
disinfectants, contact INFORS HT.
NOTICE
Insufficient cleaning and disinfection can lead to damage to cultures
due to contamination.
Mild detergents, e.g. dishwashing liquid or neutral cleaning agents, are
suitable for all surfaces:
Exterior surfaces of the casing
■
Front window
■
Interior surfaces of the casing
■
Steel plate covers
■
Table
■
Trays (incl. clamps and other holders)
■
NOTICE
Aggressive detergents, solvents and abrasive cleaning utensils (hard
sponges, brushes) can scratch surfaces, damage the device and
impair its function.
To clean the surfaces, use a soft cloth, ideally lint-free. This applies in
particular to the front window. Disinfect using commercially available
disinfectant if necessary.
When cleaning the base tray, only use a wet cloth, never pour water
into the tray. Make sure that no water splashes into the bearings. After
cleaning the device, especially the interior and the base tray, dry it
with a cloth.
Multitron Standard - Operating manual
Cleaning and Maintenance
Page 81 of 104