Mounting The Holders - Infors HT MULTITRON STANDARD Operating Manual

6.2.3

Mounting the Holders

29.11.2024
If you are unable to insert the tray correctly, perform
the following checks:
− Remove the tray and check it is not twisted or
bent.
− Check the incubation chamber for foreign objects
and remove these.
−
If it is still not possible to insert the tray correctly,
contact your nearest INFORS HT representative.
NOTICE
The threaded holes of the tray can be damaged if the fastening
screws are not screwed straight into the thread.
− Place the screws vertically on the drill holes.
− Ensure they can be tightened easily.
NOTICE
All holders are supplied with pre-fitted screws. If a test tube holder
or box for microtitre plates is placed on the Sticky Stuff adhesive
matting, there is a risk that the adhesive matting is damaged by
protruding screws.
Remove the screws before you place test tube holders or microtitre
plates on the Sticky Stuff adhesive matting.
Multitron Standard - Operating manual
Operation
Page 57 of 104