Infors HT MULTITRON STANDARD Operating Manual page 60

Multitron Standard - Operating manual
Operation
6.3 Setting, Activating and Deactivating Parameters
Setting the Setpoint and Switching
on the Parameter
Kopiervorlagen diverse
Kopiervorlage Bilderrahmen
Page 60 of 104
Kopiervorlagen diverse Kopiervorlagen diverse Kopiervorlagen diverse
To set the setpoint for a parameter and switch on the parameter,
proceed as follows:
Kopiervorlage Bilderrahmen Kopiervorlage Bilderrahmen Kopiervorlage Bilderrahmen
RPM
1.
2.
3.
The parameter that can be set is always displayed in
the right view box (1).
1
°C
Press the F button (2) to select the parameter in question.
�� The right display (1) shows either the current actual value of
the parameter or alternately the setpoint and the message
OFF .
Press the Plus or Minus button (3) to set the setpoint you want
to use for the selected parameter. You can scroll through value
range in steps of ten by holding the Plus or Minus button down.
�� The entered value is saved automatically. A separate confir-
mation is not necessary. If the parameter is already activated,
the changes take effect immediately.
To switch on the parameter, press the On/Off button (4).
�� The parameter is activated immediately.
�� The display briefly shows the message
rent actual value.
When starting up the shaker drive, use the time until
the setpoint is reached to check whether the cultiva-
tion flasks are secured on the tray.
The parameters need a little time to reach their set
setpoints. Until they have done so, the messages
Lo is displayed, depending on whether the actual
or
value is higher or lower than the setpoint.
2 3 4
F
FT
on and then the cur-
29.11.2024
Hi