Tips & Tricks For Loading The Tray - Infors HT MULTITRON STANDARD Operating Manual

6.2.4 Tips & Tricks for Loading the Tray
29.11.2024
Observe the following notices when loading the tray:
The working volume should not exceed 1/3 of the total volume of
■
the vessel.
To ensure smooth operation, place the cultivation flasks symmetri-
■
cally in the middle of the tray. Do not place heavy vessels at the
edge of the tray.
If the flasks extend beyond the edge of the tray, they may be
■
damaged or broken if they collide with the wall of the device.
Therefore, always position cultivation vessels on the tray so that
they do not protrude.
If the tray is only loaded lightly and is going to be run at high rota-
■
tion speeds, place additional cultivation vessels filled with water
on the tray. This will make the device run smoothly.
At shaker speeds of approx. 200 min
on the throw and the position of stacked device units), the load
distribution plays only a minor role.
CAUTION
If the loading mass of the table is too high or too low or the load is
distributed unevenly, high rotation speeds can cause vibrations. This
can result in the device moving uncontrollably.
− Never operate the device without a tray and loading.
− In case of strong vibrations, reduce the rotation speed and
check the loading weights or the distribution of the load.
Multitron Standard - Operating manual
Operation
to 250 min (depending
-1 -1
Page 59 of 104