Infors HT MULTITRON STANDARD Operating Manual page 65

Kopiervorlagen diverse
Setting the Setpoints for Phase 2 (FT Button)
Kopiervorlage Bilderrahmen
Kopiervorlagen diverse Kopiervorlagen diverse Kopiervorlagen diverse
Only for Cyclical Changes: Setting the Timer for Phase 2 (FT Button)
Kopiervorlage Bilderrahmen Kopiervorlage Bilderrahmen Kopiervorlage Bilderrahmen
One-time Change
29.11.2024
Kopiervorlagen diverse Kopiervorlagen diverse
1
Kopiervorlage Bilderrahmen Kopiervorlage Bilderrahmen
FT
RPM
8. Press the FT button (2) to select the parameter (RPM or °C) in
question.
�� The next phase (
9. Press the Plus or Minus button (3) to set the setpoint you want
Kopiervorlagen diverse Kopiervorlagen diverse
to use for the selected parameter.
10. Press the On/Off button (4) to activate the parameter.
11. Repeat steps 8 – 10 as necessary for the other parameters.
1
Kopiervorlage Bilderrahmen Kopiervorlage Bilderrahmen
FT
RPM
12. Press the FT button (3) to select the timer function
�� The
13. Use the Plus or Minus button (4) to set the required duration.
14. Press the On/Off button (5) to activate the timer.
�� The
The device will run using the setpoints set for the first phase until the
set time elapses. The
duration. At the end of the entered time, the setpoints for phase 2 are
activated. The
remain active until they are changed manually.
Multitron Standard - Operating manual
2
°C
FT ) function symbol (1) will light up.
2 3
Timer parameter symbol (2) lights up.
cycle active (1) function symbol will light up.
Timer active function symbol will flash for the
Timer active function symbol will go out. The setpoints
Operation
3 4
F
FT
4 5
F
FT
Page 65 of 104