Printronix T5000 Software Manual page 64

Chapter 2
Managing the Database
download terminates. If you have a slow connection between PNE and the
printer, you may need to define a longer Download Timeout period.
The Download Timeout range is between 1 and 60 minutes. The default is
2 minutes.
Firmware Download Initial Delay (Sec): Specifies the number of seconds
PNE waits before sending files to the printer. If the printer is not ready within
the specified time, the download will terminate, and the Status and Error Log
will report Connection Refused.
If you receive this error message, increase the initial delay time. The default is
60 (seconds).
Network Sub-Tab
Enter the printer's IP Address and Port Number. (Click Default to reset the
Port Number to 3001.) The Time Out option sets the amount of time, in
seconds, PNE waits for a response from the printer after sending a command.
If there is no response in the specified amount of time, an error message
appears in the Status and Error Log pane. If you have a slow connection
between PNE and the printer, you may need to define a longer Time Out
period. Define the Time Out between 5 and 300 seconds (the default is 15
seconds).
NOTE: The Network settings must match the settings in the operator panel
64
Figure 48. Printer Properties: Connections – Network Sub-Tab
menu. See "ETHERNET PARAMS", "ETHERNET ADDRESS", or
"WIRELESS ADDRESS" in the printer's User's Manual to check the
IP address.
To check the port number on the printer, see "Check Port Number" on
page 16.