Printronix T5000 Software Manual page 46

Chapter 2
The Menu Bar
Alert Delivery Tab
Select Status Properties to open the Status Monitoring Properties dialog
box. Click the Alert Delivery tab. Check the Enable Notification check box
to enable the option. The Alert Delivery properties allow you to customize the
way PNE notifies you of potential printer errors. Descriptions of the three alert
types follows:
1. Alert Log: Allows PNE to log alerts to a file located in the PNE installation
directory. To log alerts, check the Enable Log File check box, then click
Add (see Figure 31). A task item adds to the log list. In the task item,
specify the following as applicable, then click Apply or OK.
46
Figure 31. Status Monitoring Properties:
Alert Delivery Tab – Alert Log Sub-Tab
Log File: To name the log file. The default file name is alerts.log.
Size: To set the maximum file size, in bytes. The default (and
minimum required) size is 1000 bytes.
Device: To choose a device item you want PNE to monitor, such as a
folder, specific printer, or a range of IP addresses.
First: To set the beginning IP address in a polling range. Use this
option if you select Range: as the Device option.
Last: To set the last IP address in a polling range. Use this option if
you select Range: as the Device option.