Printronix T5000 Software Manual page 272

Chapter 7
Data Validation
Other Error Messages
• Calibration Warning: In some cases, the validator can determine if it is
out of calibration. When this occurs, the validator will communicate this
condition as part of a bar code report. This condition is considered a
warning and the printer will not stop.
NOTE: If a bar code failure is also reported in the same bar code report, then
When the calibration warning condition is encountered, the message
"Validator needs calibration" displays. Normal operation will continue
during this warning. To clear the message, press the PAUSE key.
Once the message has been cleared, perform the calibration procedure
(see "Calibration" in the Online Data Validator User's Manual). Whether or
not you perform a calibration will be unknown to the printer. Once the
warning message has been cleared, the printer will assume that any
problem has been resolved and will function as normal.
• Overall Grade Failure: This is an overall data validation failure. One or
more of the following errors has occurred: Decodeability, Percent
Decode, Defects, Modulation, Minimum Edge Contrast (EC Min),
Minimum Reflectance (Rmin), and/or (Symbol) Contrast.
The printer's next action depends on the error action setting. If the Stop
mode is selected, printing resumes where the printing stopped. If the
Overstrike or Reprint modes are selected, the printer assumes the last
label failed and takes the appropriate action. See "Error Action" in the
Online Data Validator User's Manual.
RFID
This is the message assigned for an RFID failure.
Pass = no RFID failure
Tag Failure = RFID failure
8. Job ID
The default is 65535. For future use.
9. Pages Completed
The default is 0. For future use.
272
failure error handling will take precedence.