Printronix T5000 Software Manual page 208

Printnet enterprise suite
Hide thumbs Also See for T5000:
Table of Contents

Advertisement

Chapter
6
Overview
Printer Powered Up
This event is delayed until the moment the printer reaches the Powered-
up-online or Powered-up-offline state. The delay is required so the printer
can finish its power-on reset cycle before any reaction to an event
generates.
NOTE: With the advanced GPIO features enabled in the printer, GPIO will
Printer Online
When the printer goes online by pressing the Pause key, the action
related to this event is accepted.
Printer Offline
When the printer goes offline by pressing the Pause key or the menu key,
or if there is any other reason that causes the printer to switch offline, the
action related to this event is accepted.
Printer Paused
This event happens when the printer pauses because of the "pause
printer" action. The printer will accept data from the host and parse this
data until its buffers are full. No printing will take place. The print engine is
offline but the printer's data processing unit is still online.
Power Save Mode Active
This event signals the moment when the printer enters Power Save
Mode.
Power Save Mode Cleared
This event signals when the printer becomes active again.
Start Data Processing
This event signals the start of the processing of received data. This is not
the same as the Start Printing event.
End Data Processing
This event signals the end of the data processing cycle. This is not the
same as the end printing event.
Printer Buffers Empty
This event takes place as soon as the print buffers are emptied.
Single Form Printing Invoked
This event happens on the Enter Single Label Mode action. It indicates
that this mode has been entered.
Continuous Form Printing Invoked
This event indicates that the Single Form Mode is terminated and that
normal, continuous printing is active.
208
"Data Fields" on page 224). This results in 248 different input
combinations that can be used to trigger an action.
either start up using the printer configuration or a predefined
configuration. Select File GPIO Configuration then select the
Power-Up Settings, GPIO Control tab to set the power-up option.

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the T5000 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents

Save PDF