Printronix T5000 Software Manual page 238

Chapter 6
Timers
4. Enter 2 in the MM field under Initial Delay.
This specifies a two minute initial delay in which the operator has two
minutes to reload ribbon. If the operator is able to change the ribbon and
place the printer online within two minutes, the delay timer stops. If the
operator is unable to change the ribbon within the two minutes, then the
delay timer starts and the printer gives a warning. The delay timer will
repeat for a specified amount of time until the error is cleared.
5. Enter 10 in the SS field under Delay.
If the operator is unable to change the ribbon within two minutes as
specified in the previous step, then the delay timer starts in 10 seconds.
In 10 seconds the printer will give a warning. The warning will repeat
every 10 seconds until the error is cleared.
6. Click Add. The Ribbon Reloading Error delay timer is added to the Timer
list. See Figure 208.
7. Click OK.
238
Figure 208. Setting a Delay Timer