Printronix T5000 Software Manual page 215

Action Name
Beep
Blink
General
Disable GPIO Events
Enable GPIO Events
Reply to Host
Wait
PAA Control: Reset
CST
Select Mapping Table
Data Field
3
Send Report
Table 10. Event Actions and Parameters
Description
This action defines the number of
times the buzzer beeps.
This action changes the state of a
printer's led or lamp.
This action prohibits the Event
Parser from executing any actions
except for the Enable Event
Parser action. This allows an
application to temporary disable
the GPIO Event Parser.
This action allows the Event
Parser to start executing all
actions again.
This action sends user defined
data to the host.
This action waits a specified time
before the next action on the same
event is performed.
Use the data field to specify the
time to wait. Only available if one
of the numeric data fields is
defined.
Time to wait in msThis action will
reset the active CST.
This action allows the user to
select the active mapping table.
This action is only enabled if there
is more than one mapping table.
Performs an action on a user-
defined data field. If no data fields
are defined, the user is asked to
define data fields first.
This action allows the user to send
a report to a destination. If no
reports are defined, the user is
asked to define reports first.
Events And Actions
Parameters
Beep Count
State, LED/Lamp
None
None
Reply, Interface
Time to Wait in
milliseconds
None
Name of Table to
switch to.
Destination, Operator,
Source, Type
Source, Destination,
Seconds
Security Key
Required
215