Appendix D Physical Button (Dynaflex Only) - Magtek DynaFlex II Go Programmer's Manual

Appendix D - Physical Button (DynaFlex Only)
Appendix D
All DynaFlex devices have a single physical button. On the DynaFlex II Go, it is located on the left side.
On all other DynaFlex models, the button on the back of the device near the USB port. Pressing and
holding this button can activate extra functions on the device. To active a specific function, press and
hold the button until a specific number of beeps are heard. Table G8.7-48 shows which functions can be
activated. Beep counts that are not listed are not supported.
Table G8.6-48 – Button Functions
Beep Count
Power Off
2
Hold for two beeps to power the device off. The device will reboot if it is
connected to USB when powered off.
Settings Menu
3
SoftAP Mode in the Settings Menu is Available on WLAN enabled devices
only.
BLE Pairing
4
BLE Enabled devices only.
Demo
5
See Appendix C for more information.
Battery Level
Light the LEDs to indicate the current state of charge of the battery. The LEDs
will light for 3 seconds then return to their original state.
6
DynaFlex II Go has only green LEDs. Instead of lighting the first LED in
amber, it will slowly flash the first LED. Instead of Red, the first LED will
flash quickly.
DynaFlex II Go| Secure Card Reader | Programmer's Manual (COMMANDS)
Physical Button (DynaFlex Only)
Page 294 of 301 (D998200597-102)
Function