Property 1.2.7.1.2.1 User Event Notification Controls Enable - Magtek DynaFlex II Go Programmer's Manual

Secure card reader
Hide thumbs Also See for DynaFlex II Go:
Table of Contents

Advertisement

8 - Configuration
Table 8.3-117 - Set Request Example
AA00 81040155D111 8411 D111 8501 01 8704 02070101 8904 C402 FFFF
Table 8.3-118 - Set Response Example
AA0081048255D11182040000000084820011D1118501018704020701018904C402FFFF

8.3.5.5 Property 1.2.7.1.2.1 User Event Notification Controls Enable

Table 8.3-119 - Property 1.2.7.1.2.1 User Event Notification Controls Enable
Property OID 1.2.7.1.2.1 / 0x010207010201
Name
User Event Notifications Enable
The host can use this property to enable notification reasons defined in Notification
0x1001 - Device Information Update in the User Events Category. Each bit enables a
specific Reason by setting that bit to 1. Byte 0 is the first byte, bit 0 is the LSB of each
byte.
The device only detects these user events and sends these notifications when it is idle.
While processing a command (not idle), such as when processing a transaction with
Command 0x1001 - Start Transaction, the device only sends notifications related to
Description
the command it is currently processing.
Notification reasons may consume power when idle. For example, enabling Contactless
reasons requires the device to continuously consume some radio frequency power to
detect the presence of a contactless card when idle. To conserve power, only enable the
notification reasons that are required by the solution design, if any. The readers and their
associated notifications will be disabled if the battery charge is 5 percent or lower.
Changes to this property do not take effect until the device is power cycled or reset.
Securing Key None
Min. Len (b)
4
Max. Len (b) 4
Data Type
Binary
Byte 0
bit 0 = Reason: Contactless Card Presented
bit 1 = Reason: Contactless Card Removed
Valid Values
bit 2 = Reason: Card Seated in Slot
bit 3 = Reason: Card Unseated from Slot
bit 4 = Reason: Card Swiped
bit 5 = Reason: Touch Sensor Press Detected
DynaFlex II Go| Secure Card Reader | Programmer's Manual (COMMANDS)
Example (Hex)
Example (Hex)
Bit Property Description
Page 235 of 301 (D998200597-102)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DynaFlex II Go and is the answer not in the manual?

Questions and answers

Table of Contents