Property 1.2.7.1.4.1 Device Low Temperature Notification Level - Magtek DynaFlex II Go Programmer's Manual

8 - Configuration

8.3.5.8 Property 1.2.7.1.4.1 Device Low Temperature Notification Level

Table 8.3-133 - Property 1.2.7.1.4.1 Device Low Temperature Notification Level
Property OID 1.2.7.1.4.1 / 0x010207010401
Name Device Low Temperature Notification Level
The device will send a low temperature notification when the device's temperature falls
below this temperature. The temperature is in degrees Celsius.
Description
The Device Low Temperature Notification Level takes effect immediately after the host
changes it.
Securing Key None
Min. Len (b) 1
Max. Len (b) 1
Data Type Signed Binary
Temperature in Celsius:
DynaProx:
Valid Values DynaProx BCR: 0xEC .. 0x37 (-20 .. 55)
DynaFlex:
This value must be less than that set in 1.2.7.1.4.2.
Temperature in Celsius:
DynaProx:
Default
DynaProx BCR: 0xEC (-20)
DynaFlex:
Table 8.3-134 - Get Request Example
AA00 8104 0155D101 840F D101 8501 01 8704 02070104 8902 C100
Table 8.3-135 - Get Response Example
AA00 8104 8255D101 8204 00000000 84820010 D101 8501 01 8704 02070104 8903 C101 00
Table 8.3-136 - Set Request Example
AA00 81040155D111 8410 D111 8501 01 8704 02070104 8903 C101 05
Table 8.3-227 - Set Response Example
AA00 8104 8255D111 8204 00000000 84820010 D111 8501 01 870402070104 8903 C101 05
DynaFlex II Go| Secure Card Reader | Programmer's Manual (COMMANDS)
Property Description
0xE2 .. 0x55 (-30 .. 85)
0x00 .. 0x2D (0 .. 45)
0xE2 (-30
0x00 (0)
Example (Hex)
Example (Hex)
Example (Hex)
Example (Hex)
Page 239 of 301 (D998200597-102)