Property Subgroup 1.2.7.Nnn System Settings; Property 1.2.7.1.1.1 Device Reset Occurred Notification Control - Magtek DynaFlex II Go Programmer's Manual

8 - Configuration
Table 8.3-99 - Set Response Example
AA 00 81 04 82 5D D1 11 82 04 00 00 00 00 84 82 00 1B D1 11 81 07 2B 06 01 04 01 F6 09 85 01 01
89 0B E2 09 E3 07 E2 05 E1 03 C1 01 01

8.3.5 Property Subgroup 1.2.7.nnn System Settings

8.3.5.1 Property 1.2.7.1.1.1 Device Reset Occurred Notification Control

Table 8.3-100 - Property 1.2.7.1.1.1 Device Reset Occurred Notification Control
Property OID 1.2.7.1.1.1 / 0x010207010101
Name Device Reset Occurred Notification Control
The device uses this property to control behavior of the Device Reset Occurred
notification in Notification 0x1001 - Device Information Update.
Description
Changes to this property do not take effect until the device is power cycled or reset.
Securing Key None
Min. Len (b) 1
Max. Len (b) 1
Data Type Binary
0x00 = Never send this notification.
0x01..0xFE = The frequency in seconds the device should repeat sending the notification
Valid Values until the host requests that it stop with Property 1.2.7.1.1.2 Device Reset Occurred
Notification Acknowledged.
0xFF = Only send this notification once.
Default 0x00
Table 8.3-101 - Get Request Example
AA 00 81 04 01 55 D1 01 84 0F D1 01 85 01 01 87 04 02 07 01 01 89 02 C1 00
Table 8.3-102 - Get Response Example
AA 00 81 04 82 55 D1 01 82 04 00 00 00 00 84 82 00 10 D1 01 85 01 01 87 04 02 07 01 01 89 03 C1
01 00
Table 8.3-103 - Set Request Example
AA 00 81 04 01 55 D1 11 84 10 D1 11 85 01 01 87 04 02 07 01 01 89 03 C1 01 05
DynaFlex II Go| Secure Card Reader | Programmer's Manual (COMMANDS)
Example (Hex)
Property Description
Example (Hex)
Example (Hex)
Example (Hex)
Page 231 of 301 (D998200597-102)