Property 1.1.1.1.1.6 Arpc Retry Attempts - Magtek DynaFlex II Go Programmer's Manual

8 - Configuration

8.2.1.6 Property 1.1.1.1.1.6 ARPC Retry Attempts

Table 8.2-26 - Property 1.1.1.1.1.6 ARPC Retry Attempts
Property OID 1.1.1.1.1.6 / 0x010101010106
Name ARPC Retry Attempts
The device uses this property to control its ARPC Retry Attempts. If a timeout occurs
when the device is waiting for the host to send Command 0x1004 - Resume
Transaction with ARPC data, the device re-sends Notification 0x0101 - Transaction
Description
Information Update to report ARQC Update and waits for ARPC data again, up to the
number of retries specified by this property. After the final retry, the device continues
with the transaction.
Securing Key None
Min. Len (b) 1
Max. Len (b) 1
Data Type Binary
Valid Values 0x00..0xFF
Default 0x00
Table 8.2-27 - Get Request Example
AA00 8104 0155D101 840F D101 8501 01 8704 01010101 8902 C600
Table 8.2-28 - Get Response Example
AA 00 81 04 82 55 D1 01 82 04 00 00 00 00 84 82 00 10 D1 01 85 01 01 87 04 01 01 01 01 89 03 C6
01 00
Table 8.2-29 - Set Request Example
AA00 81040155D111 8410 D111 850101 870401010101 8903 C60100
Table 8.2-30 - Set Response Example
AA 00 81 04 82 55 D1 11 82 04 00 00 00 00 84 82 00 10 D1 11 85 01 01 87 04 01 01 01 01 89 03 C6
01 00
DynaFlex II Go| Secure Card Reader | Programmer's Manual (COMMANDS)
Property Description
Example (Hex)
Example (Hex)
Example (Hex)
Example (Hex)
Page 180 of 301 (D998200597-102)