Command Group 0X11Nn - Nfc/Mifare Pass Through Commands (Contactless Only); Command 0X1100 - Pass Through Commands For Nfc Tag Type 2 - Magtek DynaFlex II Go Programmer's Manual

6 - Commands
Table 6.1-13 - Response Example
AA 00 81 04 82 13 10 08 82 04 00 00 00 00
6.2 Command Group 0x11nn - NFC/Mifare Pass Through Commands
(Contactless Only)
6.2.1 Command 0x1100 – Pass Through Commands for NFC Tag Type 2
After a NFC Tag is activated, the host use this command to send commands and receive responses to and
from a NFC Tag
Table 6.2-1 - Request Data for Command 0x1100 – Pass Through Commands for NFC Tag Type 2
Tag Len
Beginning of any wrappers, at minimum including Request Message found on page 32
1100 = Command 0x1100 – Pass Through Commands for NFC Tag Type 2
Command to Send.
81 var
See Table 6.2-2 – NFC Commands
00 – No Encrypt
82 01
01 - Encrypt
00 – Expect More Commands
01 – FF (Last Command)
If the pass-through command is the last successful command,
83 01 the device will end the transaction with a single beep,
indicating success. If an error arises, the device will end the
transaction but will sound two beeps to indicate the error. The
user should then remove the card.
End of any wrappers, at minimum including Request Message found on page 32
Table 6.2-2 – NFC Commands
Command Length
Get Version 1
DynaFlex II Go| Secure Card Reader | Programmer's Manual (COMMANDS)
Example (Hex)
Value / Description
The GET_VERSION command is used to retrieve information on the
NTAG family, the product version, storage size and other product data
required to identify the specific NTAG21x.
Byte 0 = 0x60
Page 102 of 301 (D998200597-102)
Typ Req
B
B
B
Field Value
Default
R
R
R