Command Group 0X1Fnn - Device Control; Command 0X1F01 - Reset Device - Magtek DynaFlex II Go Programmer's Manual

6 - Commands
6.4

Command Group 0x1Fnn - Device Control

6.4.1 Command 0x1F01 - Reset Device

The host uses this command to reset the device.
The sequence of events is as follows:
1) The host constructs the command request for Command 0x1F01 - Reset Device in the format below.
2) The host sends the command request to the device.
3) The device sends a response in the format below to the host.
4) The device starts an automatic reset within 500ms.
Table 6.4-1 - Request Data for Command 0x1F01 - Reset Device
Tag Len
Beginning of any wrappers, at minimum including Request Message found on page 32
1F01 = Command 0x1F01 - Reset Device
Power Off Option
•
0x00 = Reset
•
0x01 = Power Off
81 01
Power off only works while a device is running on its battery. If
a device is powered off while it is powered by USB, the device
will immediately turn back on.
End of any wrappers, at minimum including Request Message found on page 32
Table 6.4-2 - Response Data for Command 0x1F01 - Reset Device
Tag Len
Beginning of any wrappers, at minimum including Response Message found on page 33
1F01 = Command 0x1F01 - Reset Device
No parameters.
End of any wrappers, at minimum including Response Message found on page 33
Table 6.4-3 - Request Example
AA 00 81 04 01 12 1F 01 84 02 1F 01
Table 6.4-4 - Response Example
AA 00 81 04 82 12 1F 01 82 04 00 00 00 00
DynaFlex II Go| Secure Card Reader | Programmer's Manual (COMMANDS)
Value / Description
Value / Description
Example (Hex)
Example (Hex)
Page 114 of 301 (D998200597-102)
Typ Req Default
B O 0x00
Typ Req Default