Command 0X1101 - Pass Through Command For Mifare Classic, Type 2 - Magtek DynaFlex II Go Programmer's Manual

6 - Commands
6.2.2 Command 0x1101 – Pass Through Command For Mifare Classic, Type 2
After a MIFARE Tag is activated, the host uses this command to send commands and receive responses
to and from a MIFARE tag.
Table 6.2-8 - Request Data for Command 0x1101 - Pass Through Command For Mifare Classic
Tag Len
Beginning of any wrappers, at minimum including Request Message found on page 32
1101 = Command 0x1101 – Pass Through Command For Mifare Classic, Type 2
Command to Send.
81 var
See Table 6.2-9 – MIFARE Classic Commands
00 – No Encrypt
82 01
01 - Encrypt
00 – Expect More Commands
01 – FF (Last Command)
83 01
If last command, Device will provide a single beep after
receiving a successful response from tag, otherwise, device will
provide a double beep
End of any wrappers, at minimum including Request Message found on page 32
Table 6.2-9 – MIFARE Classic Commands
Command Length
Mifare Read
Mifare Write
DynaFlex II Go| Secure Card Reader | Programmer's Manual (COMMANDS)
Value / Description
Byte 0 – 0x30 – Read Command
Byte 1- Sector Number to Read
Byte 2 – Start Block Number
Byte 3 – End Block Number
Byte 4 – Key Type, 0 = A, 1 = B
Byte 5 to 10 = 6 Byte Key
Byte 0 – 0xA0 – Write Command
Byte 1- Sector Number to Write
Byte 2 – Start Block Number
Byte 3 – End Block Number
Byte 4 – Key Type 0 = A, 1 = B
Byte 5 to 10 = 6 Byte Key
Byte 11 to x = Variable length Byte Data (16 bytes per block)
Page 106 of 301 (D998200597-102)
Typ Req
B
B
Field Value
Default
R
R