Program Mode - Omron E5EK PROGRAMMABLE TYPE User Manual

• The parameters in this mode can be used only when the "security" parameter
(protect mode) is set to "0" to "4".
• This mode contains the parameters that you use for programming.
• To select this mode, press the
to the menu display. If you select [
press the key for 1 second minimum, the controller enters the program mode.
• To select parameters in this mode, press the
tings, use the or
• The following table shows the parameters supported in this mode and the page
where the parameter is described.
Symbol
Pattern No.
Number of steps
Step 0 SP or Target SP 0
Ramp rate 0
Step 0 time or Soak time 0
|
Step 7 SP or Target SP7
Ramp rate 7
Step 7 time or Soak time 7
Step 8 SP
Step 8 time
|
Step 15 SP
Step 15 time
Pattern execution count
Alarm value 1
Alarm value 2
Alarm value 3
Time signal 1 enabled step
Time signal 1 ON time
Time signal 1 OFF time
Time signal 2 enabled step
Time signal 2 ON time
Time signal 2 OFF time
*1 This parameter is described as a level 0 mode parameter. For details, see page 5-7.
key for 1 second minimum. The display changes
] using the
keys.
Parameter Name
|
|

Program Mode

and keys, and then
key. To change parameter set-
Page
5-7 *1
5-12
5-12
5-13
5-13
5-12
5-13
5-13
5-12
5-13
5-12
5-13
5-14
5-14
5-14
5-14
5-15
5-15
5-16
5-15
5-15
5-16
5--11