Expansion Mode - Omron E5EK PROGRAMMABLE TYPE User Manual

CHAPTER 5 PARAMETERS

Expansion Mode

• The parameters in this mode can be used only when the "security" parameter
(protect mode) is set to "0" and "1".
• This mode contains the parameters for setting expanded functions. These parame-
ters include parameters for setting the SP setting limitter, selecting advanced PID
and ON/OFF control, and setting the program time unit, step time/rate of rise
programming, time unit of ramp rate and the automatic return of display mode.
• To select this mode, press the
to the menu display. If you select [
press the
mode.
• To select parameters in this mode, press the
tings, use the
• The following table shows the parameters supported in this mode and the page
where the parameter is described.
5--38
key for 1 second minimum, the controller enters the expansion
or keys.
Symbol
Set point upper limit
Set point lower limit
PID/ON/OFF
Operation at power ON
End condition
Program time unit
Step time/Rate of rise programming
Time unit of ramp rate
PV start
Wait width
Alarm during ramp step enable
Run all enable
α
AT calculated gain
Automatic return of display mode
AT hysteresis
LBA detection width
key for 1 second minimum. The display changes
] using the
key. To change parameter set-
Parameter Name
and keys, and then
Page
5-39
5-39
5-39
5-40
5-40
5-41
5-41
5-42
5-42
5-43
5-43
5-43
5-44
5-44
5-45
5-45
5-45