Omron E5EK PROGRAMMABLE TYPE User Manual page 130

CHAPTER 5 PARAMETERS
Expansion Mode
Operation at power ON
Selects one of the following operations when the power is turned ON:
• "Continue" :
was
Function
• "Reset"
• "Run"
• "Manual"
"Manual" cannot be selected when Auto/Manual key operation is protected.
"
Setting
F Related description
4.7 Setting Running Conditions/Operation at power ON (page 4-14)
See
End condition
• Specifies a reset state or continued control on the SP of the final step after pro-
gram operation ends.
• The program end state will not change when the "number of steps" parameter
Function
setting has been changed after program operation ends. However, when control on
the SP is continued, the SP of the final step is selected after the number of steps
has been changed.
"
Setting
F Related description
4.7 Setting Running Conditions/End condition (page 4-15)
F Related parameter
See
"Number of steps" (program mode)
5--40
Starts operations from the state that was active when the power
interrupted.
: Resets the controller.
: Starts normal program operation.
: Sets the controller to the manual mode.
Setting Range
" :Continue/ " " :Reset/ "
Setting Range
" :Reset/ " " :Continued control using final SP
" Run/ " " :Manual
Default
Default