Program Mode - Omron e5ck User Manual

• The parameters in this mode can be used only when the security" parameter (pro
tect mode) is set to 0" to 4".
• This mode contains the parameters that you use for programming.
• To select this mode, press the
to the menu display. If you select [
the key for 1 second minimum, the controller enters the program mode.
• To select parameters in this mode, press the
use the or keys.
• The following table shows the parameters supported in this mode and the page where
the parameter is described.
Symbol
Pattern No.
Number of steps
Step 0 SP or Target SP 0
Ramp rate 0
Step 0 time or Soak time 0
|
Step 7 SP or Target SP7
Ramp rate 7
Step 7 time or Soak time 7
Step 8 SP
Step 8 time
|
Step 15 SP
Step 15 time
Pattern execution count
Alarm value 1
Alarm value 2
Alarm value 3
Time signal 1 enabled step
Time signal 1 ON time
Time signal 1 OFF time
Time signal 2 enabled step
Time signal 2 ON time
Time signal 2 OFF time
*1 This parameter is described as a level 0 mode parameter. For details, see page 5 7.

Program Mode

key for 1 second minimum. The display changes
] using the
key. To change parameter settings,
Parameter Name
|
|
and keys, and then press
Page
5-7 *1
5-12
5-12
5-13
5-13
5-12
5-13
5-13
5-12
5-13
5-12
5-13
5-14
5-14
5-14
5-14
5-15
5-15
5-16
5-15
5-15
5-16
5–11