Protect Mode - Omron E5EK PROGRAMMABLE TYPE User Manual

3.6 Protect Mode

J Security
J Key protect
• This parameter allows you to protect until start of operation parame-
ters that do not change during operation to prevent unwanted modifi-
cation.
• The set value of the "security" parameter (protect mode) limits the
range of protectable parameters. The following table shows the rela-
tionship between set values and the range of protection. (Only modes
marked by F can be operated.)
Mode Mode
Calibration
Option
Expansion
Setup
Level 2
Level 1
Program
Level 0
*1 Only the "PV/Present SP" parameter can be displayed.
• When this parameter is set to "0", parameters are not protected.
• When this parameter is set to "5", operations in only the level 0 mode
can be selected, and the mode is not displayed on the menu display.
• When this parameter is set to "6", the "PV/Present SP" parameter
can only be monitored.
• Default is "1".
• This parameter disables key operation for switching run/reset or
auto/manual. For example, if you protect the key operation for switch-
ing auto/manual by the "key protect" parameter (protect mode) dur-
ing automatic operation, the controller cannot be set to the manual
mode, preventing manual operation of the controller during opera-
tion.
• The following table shows the relationship between set values and
keys that are protected.
Set value
Key protection OFF
0
A/M cannot be selected.
1
RUN/RST cannot be selected.
2
Both A/M and RUN/RST cannot be selected.
3
• Default is "0 : All keys can be operated."
Set value
0 1 2 3
F F
F F
F F
F F
F F F
F F F F
F F F F
F F F F
Description

3.6 Protect Mode

4 5 6
F
*1
F F
3--19