Command Structure - Omron E5EK PROGRAMMABLE TYPE User Manual

6.3 Command Structure

Command
Response
End code = 00
Response
End code = 00
About invalid
parameters
Command structure is as follows. Each command is paired with a re-
sponse.
2B 1B 2B
Unit Command
code
No.
@
Command type
2B 1B 2B
Unit
Command
code
No.
@
Command type
2B 1B 2B
Unit Command
code
No.
@
Command type
• "@"
The start character. This character must be inserted before the lead-
ing byte.
• Unit No.
Specifies the "unit No." of the E5EK-T. If there are two or more trans-
mission destinations, specify the desired destination using "unit No."
• Command type
Code
1
2
3
4
5
• Command code
Specifies the command for each command type. With parameter read/
write commands and program parameter read/write commands, this
becomes the parameter No.
• Data
Specifies the set value or setting content. With the parameter read
and program parameter read commands, set dummy data "0000". In
the response, this is inserted only when the end code is "00".
Currently, if a command is used for invalid parameters (parameters that do not
satisfy the conditions of use in Chapter 5), the "undefined" error (end code: IC)
response is returned.

6.3 Command Structure

4B 2B
FCS
Data
2B 4B
End Data
code
2B 2B 2B
FCS
End
code
* CR
Command type
Parameter read
Parameter write
Special command
Program parameter read
Program parameter write
2B
* CR
2B 2B
FCS
* CR
6--5