Setup Mode - Omron E5EK PROGRAMMABLE TYPE User Manual

CHAPTER 5 PARAMETERS

Setup Mode

• The parameters in this mode can be used only when the "security" parameter
(protect mode) is set to "0" and "1".
• This mode contains the parameters for checking or setting the basic specifications
of the E5EK-T controller. These parameters include parameters for specifying the
input type, scaling, output assignments, and direct/reverse operation.
• To select this mode, press the
to the menu display. If you select [
press the
• To select parameters in this mode, press the
tings, use the
• The following table shows the parameters supported in this mode and the page
where the parameter is described.
5--30
key for 1 second minimum, the controller enters the setup mode.
or keys.
Symbol Parameter Name
Input type
Scaling upper limit
Scaling lower limit
Decimal point
_C/_F selection
Parameter initialize
Control output 1 assignment
Control output 2 assignment
Auxiliary output 1 assignment
Auxiliary output 2 assignment
Alarm 1 type
Alarm 1 open in alarm
Alarm 2 type
Alarm 2 open in alarm
Alarm 3 type
Alarm 3 open in alarm
Direct/Reverse operation
key for 1 second minimum. The display changes
] pressing the
key. To change parameter set-
and keys, and then
Page
5-31
5-32
5-32
5-32
5-33
5-33
5-34
5-34
5-35
5-35
5-36
5-37
5-36
5-37
5-36
5-37
5-37