Relationships Between Simple Programs And Other Functions - Omron E5AN-H User Manual

Using the Simple Program Function
SP Start

4-16-4 Relationships between Simple Programs and Other Functions

138
Program operation can be started by using an SP start from the bank 0 LSP.
To use an SP start, set the SP Ramp Set Value and Soak Time parameters for
bank 0 to 0.
Example Bank 0 SP: 30
Bank 0 SP ramp set value: OFF
Bank 0 soak time: 0
SP=100
Ramp SP
SP=30
PV
Bank 1
• Changing the Soak Time
If the soak time is changed while the program is being executed, timing
will be continued from the time value at that point. The timer value will
be reset, however, if a power interruption occurs.
• Changing the SP
If the soak time is changed while the program is being executed, timing
will be continued from the timer value at that point.
• Input Errors
Timing will be continued even if an input error occurs during operation
in program mode.
Note Timing will be performed according to the PV at the time of the input
error (i.e., the sensor input setting range upper limit).
• Changing to Manual Mode
Timing will be continued when changing to manual mode while the
simple program is being executed.
• AT
AT will be executed even if it is started while the simple program is be-
ing executed. While AT is being executed, operation will not move to
the next bank and the soak remain time will remain at 0. Operation will
move to the next bank after AT has been completed. After operation
has been completed for the end bank, one of the following operations
will be executed depending on the program pattern.
Program Pattern
STOP The STOP operation command will be executed, so AT will be
stopped.
CONT The STOP operation command will not be executed, so AT will
continue.
LOOP AT will be continued by changing to the start bank.
Bank 1 SP: 100
Bank 1 SP ramp set value: 1
Bank 1 soak time: 5
SP2
Soak time
Operation
Section 4-16
Bank 2