Omron E5AN-H User Manual page 326

Action
Control continues, allowing normal operation. The message is displayed when the PV, PV/SP, or PV/MV is dis-
played.
Resistance thermometer input (Except for models with a
setting range of −199.9 to 500.0°C)
Thermocouple input (Except for models with a setting range of
−199.9 to 400.0°C)
Control range
s.err display
Numeric display
Input indication range
Analog Input
• When display range < control range
s.err display [[[[ display
−19999
e333
AD Converter Error
Meaning
There is an error in internal circuits.
Action
First, turn the power OFF then back ON again. If the display remains the same, the Controller must be
repaired. If the display is restored, then the probable cause is electrical noise affecting the control system.
Check for electrical noise.
Operation
Control output and alarm output turn OFF.
e111
Memory Error
Meaning
Internal memory operation is in error.
Action
First, turn the power OFF then back ON again. If the display remains the same, the Controller must be
repaired. If the display is restored, then the probable cause is electrical noise affecting the control system.
Check for electrical noise.
Operation at Error
Control output and alarm output turn OFF. (Current output is approx. 0 mA).
ffff
Current Value Exceeds
Meaning
This error is displayed when the heater current value exceeds 55.0 A.
s.err display
Control range
]]]] display
Numeric display
Input indication range
Display range
32400
(See note.)
Note: The display range is shown in numbers with decimal points omitted.
Resistance thermometer input (Except for models with a
setting range of −1999. to 500.0°C)
Thermocouple input (Except for models with a setting range of
−199.9 to 400.0°C)
Control range
s.err display [[[[ display
Numeric display
Input indication range
Analog Input
• When display range > control range
s.err display s.err display
−
19999
Appendix
s.err display
Control range
s.err display
Numeric display
32400
Display range
(See note.)
305