Counting Control Output On/Off Operations; Control Output On/Off Count Function - Omron E5AN-H User Manual

Counting Control Output ON/OFF Operations

Initial Setting Level
Move to Ad-
amov
vanced Function
Setting Level
-169
Advanced Function Setting Level
Parameter
init
Initialization
off
PF Setting
pf
a-m
PF Setting
pf
pfdp
Monitor/Setting
pfd1
Item 1
1
Monitor/Setting
pfd1
Item 1
7
Initial Setting Level
Input Type
in-t
5
Operation Level
C
25.0
alm
100.0
Monitor/Setting Item Level
Monitor/Setting
C
al-1
Item Display 1
0.0

4-21 Counting Control Output ON/OFF Operations

4-21-1 Control Output ON/OFF Count Function

150
2. Select the Move to Advanced Function Setting Level parameter by press-
ing the M Key.
3. Press the D Key to enter the password (−169). It is possible to move to
the advanced function setting level by either pressing the M Key or wait-
ing two seconds without pressing any key.
4. Press the M Key to select the PF Setting parameter.
5. Press the U Key to select PFDP (Monitor/Setting Item).
6. Press the M Key to select the Monitor/Setting Item 1 parameter.
7. Press the U Key to select 7 (Alarm Value 1).
8. Press the O Key for at least one second to move from the advanced
function setting level to the initial setting level.
9. Press the O Key for at least one second to move from the initial setting
level to the operation level.
10. Press the PF Key to display Alarm Value 1 for the current bank.
If Control Output 1 and 2 are ON/OFF outputs (relay outputs, voltage outputs
for driving SSR, or SSR outputs), the number of times that a control output
turns ON and OFF can be counted. Based on the control output ON/OFF
count alarm set value, an alarm can be output and an error can be displayed if
the set count value is exceeded.
The default setting of the Control Output ON/OFF Alarm Set Value parameter
is 0. ON/OFF operations are not counted when this parameter is set to 0. To
enable counting ON/OFF operations, change the setting to a value other than
0.
Section 4-21