Setting Levels Diagram - Omron E5AN-H User Manual

Control Range
• Resistance thermometer and thermocouple input
Temperature lower limit −20°C to temperature upper limit +20°C, or temperature lower limit −40°C to
temperature upper limit +40°C
• Analog input
−5% to +105% of scaling range

Setting Levels Diagram

This diagram shows all of the setting levels. To move to the advanced function setting level and calibration
level, you must enter passwords. Some parameters are not displayed depending on the protect level setting
and the conditions of use.
Control stops when you move from the operation level to the initial setting level.
Start in manual mode.
Start in automatic mode.
a-m
Press the O Key
for at least 3 s while
a-m is displayed.
(a-m will flash after
Manual
1st second.)
mode
Press the PF Key
for at least 1 s.
Manual
Control Level
Press the O Key
for at least 1 s.
Control stops.
Note (1) You can return to the operation level by executing a software reset.
(2) It is not possible to move to other levels from the calibration level by operating the keys on the front
panel. It can be done only by first turning OFF the power.
(3) From the manual control level, key operations can be used to move to the operation level only.
336
Power ON
Operation
Level
Press the
O Key less than 1 s.
Press the
O Key less than 1 s.
PID Setting
Level
Monitor/Setting
Item Level
Initial Setting
Level
Press the O Key
for at least 1 s.
Advanced Function
Setting Level
Input password.
Calibration Level
Adjustment
Level
Press the
O Key less
than 1 s.
Bank Setting
Level
Press the
O Key less
than 1 s.
Press the O Key for at
least 3 s. (Display will flash
after 1st second.)
25.0
c
100.0
Communica-
tions Setting
Level
Press the
O Key for less than 1 s.
Control in progress
Control stopped
Not displayed for some models
Level change
Appendix
Press the O+
M Keys for at
Press
least 1 s.
the O +
M Keys
25.0
c
for at
least 3 s.
100.0
(Display
will flash
after 1st
second.)
Protect Level
Note: The time taken to
move to the protect
level can be adjusted
by changing the
"Move to protect level
time" setting.