Omron E5AN-H User Manual page 118

Using Event Inputs
Note
Controllers with Event Inputs 1 to 4 (Four Event Inputs)
Bank Numbers Used 0
1
2
3
The following table shows the relation between ON/OFF combinations of
event inputs and the banks that are selected.
Bank Event No.
Numbers
Used
1 Event input 1 (See
note 1.)
2 Event input 1 (See
note 1.)
Event input 2 (See
note 2.)
3 Event input 1
Event input 2
Event input 3
(1) For models with event inputs 3 and 4, this becomes event input 3.
(2) For models with event inputs 3 and 4, this becomes event input 4.
To set two banks are externally, make the setting in the Bank Numbers Used
parameter.
• Switching is possible between two banks (0 and 1) by setting the Bank
Numbers Used parameter to 1. The default setting is 1 and does not need
to be changed. Banks 0 and 1 are specified by the status of event input 1
or 3.
E5CN-H
11
−
EV1
EV1
12
+
EV2
EV2
13
+
Two Event Inputs:
E53-CN@B@N2
(for E5CN-H)
Event input Event input
assignment assignment
1 2
Displayed (Bank selection not used.)
Hidden (Bank, Displayed (Event inputs 2 to 4 not used for
2 points) bank selection.)
Hidden (Bank, 4 points)
Hidden (Bank, 8 points)
0 1
OFF ON
OFF ON OFF ON
OFF OFF ON
OFF ON OFF ON OFF ON OFF ON
OFF OFF ON
OFF OFF OFF OFF ON
E5AN/EN-H
EV1
11
+
EV2
12
+
13
−
Two Event Inputs:
E5AN/EN-
H@B@M@-500
(for E5AN/EN-H)
Section 4-5
Event input Event input
assignment assignment
3
Displayed (Event input 3 and
4 not used for bank selection.)
Displayed
(Event input 4
not used for
bank selec-
tion.)
Bank No.
2 3 4 5 6
--- --- --- --- ---
--- --- ---
ON --- --- ---
ON OFF OFF ON
ON ON
23 EV3
+
EV1
EV4
24
+
EV2
25
−
Two Additional Event Inputs:
E53-AKB in E5AN/EN-
H@B@M@-500
(for E5AN/EN-H)
4
7
---
---
---
ON
ON
EV3
EV4
97