Omron E5AN-H User Manual page 273

Advanced Function Setting Level
cjc
Cold Junction Compensation Method
Function
Setting
See
See
rlrv
MB Command Logic Switching
Function
Setting
See
See
252
Setting range
on: Enabled, off: Disabled
• This parameter specifies whether cold junction compensation is to be per-
formed internally by the Controller or to be performed externally when the
input type setting is 5 to 23.
• The cold junction compensation external setting is enabled when the tem-
perature difference is measured using two thermocouples.
Setting range
on: Internally, off: Externally
■ Related Parameters
Input type (initial setting level): Page 224
• This parameter switches the logic of the MB command (communications
writing switch) for the SYSWAY communications protocol
• The MB command (communications writing switch) is the equivalent of
the MB command (remote/local switch) of the E5@J.
• The setting indicated by the shaded cell indicates the default (same logic
as E5@J).
Set
value
OFF Communications writing enabled
(remote mode selection)
ON Communications writing disabled
(local mode selection)
(Terms in parentheses () are the terms used on the E5@J.)
■ Related Parameters
Communications writing (adjustment level): Page 193
Protocol setting (communications setting level): Page 281
off
Input type must be thermocouple.
on
Communications must be supported.
CompoWay/F must be selected as
the protocol.
Text data of MB command
0000
Communications writing disabled
(local mode selection)
Communications writing enabled
(remote mode selection)
Section 5-10
Default
Default
0001