Omron E5AN-H User Manual page 47

Installation
Mounting Output Units
Before Performing the
Setup
Setting Procedure
26
Gap between the Front Panel and Rear Case
Four gaps, two on the top and two on the bottom
Top View of E5AN-H
3. When inserting the body of the Digital Controller into the case, make sure
the PCBs are parallel to each other, make sure that the sealing rubber is
in place, and press the E5AN/EN-H toward the rear case until it snaps into
position. While pressing the E5AN/EN-H into place, press down on the
hooks on the top and bottom surfaces of the rear case so that the hooks
securely lock in place. Make sure that electronic components do not come
into contact with the case.
Keep the PCBs parallel to
each other and insert them
into the rear case.
Bottom View of the E5AN-H
• Confirm the type of Output Units that are to be set.
• For details on types of Output Units and the main specifications, refer to
Output Units on page 32.
• For position-proportional models and models with SSR outputs, the Out-
put Units are already set. This setting operation is not required.
• When setting the Output Units, draw out the body of the Controller from
the case and insert the Output Units into the sockets for control output 1
and 2.
• Check the socket positions to be set using the following diagram.
OUT1
OUT2
Gap between the Front Panel and Rear Case
Four gaps, two on the top and two on the bottom
Bottom View of the E5EN-H
OUT1
OUT2
E5AN-H
Section 2-1
Top View of E5EN-H
Keep the PCBs parallel to
each other and insert them
into the rear case.
E5EN-H