Editing Function Blocks - Omron CX-PROCESS TOOL V5.2 - 12-2009 Operation Manual

Creating Function Block
Registering Other Function Blocks (Loop Controller Units Only)
Display Registered Function Blocks
1, 2, 3...

3-1-7 Editing Function Blocks

Deleting Function Blocks
Copying Function Blocks
110
Note The following procedures can also be used to register a function block.
• Register the function block using the Project Workspace tree.
Select the block diagram folder, and then select Settings - Insert - Insert
Function Block.
• Register the function block by right-clicking in the block diagram.
Right-click in the block diagram to display the pop-up menu, and then select
Register and select the function block that is to be registered.
With Loop Control Units, the following block groups can be registered: Send Ter-
minal to All Nodes, Receive Terminal from All Nodes, Send Terminal to Comput-
er, CPU Unit Terminal, and SCADA Interface. For details on these function
blocks, refer to the Function Block Reference Manual.
1. Each block address registered is displayed on the tree on the Project Work-
space Screen.
The block address is displayed with the block address and function block
name as shown below.
After a function block has been registered, it can be edited using the following
operations.
Select from the project tree the function block that is to be deleted. Then either
select Settings - Delete or right-click and select Delete from the pop-up menu.
Select the function block in the Project Workspace. Right-click and select Copy
(or Cut or Paste) from the pop-up menu, or select Copy (or Cut or Paste) from
the Settings Menu.
001. Basic PID
Function block name
Block address
Section 3-1