Omron CX-PROCESS TOOL V5.2 - 12-2009 Operation Manual page 231

Creating Sequence Tables
3-8-9 Table References for LCB05 Ver. 3.0 or Later
204
For example, if a sequence table at block address 701 is expanded, three new
areas will be automatically registered as shown below.
Number of rules
Number of
Block address: 701
conditions
(The original sequence
table)
Block address: 899
(Area for the increased
number of conditions)
The table reference function enables a main sequence table (called the main
table) to reference the results of condition rules in another sequence table
(called the reference table). This enables grouping common processing in the
reference table. Enter the TBL command with the referent block address as the
input signal in the condition section and enter Y (input as is) or N (reverse input)
for the rule.
Section
Block address: 900
(Area for the increased
number of rules)
Block address: 898
(Area for the increased
number of conditions and
rules)
3-8