Monitoring Item Data For Selected Function Blocks; Downloading Individual Item Data Settings; Block Diagram Check - Omron CX-PROCESS TOOL V5.2 - 12-2009 Operation Manual

Operation Check

4-6-1 Monitoring ITEM Data for Selected Function Blocks

1, 2, 3...

4-6-2 Downloading Individual ITEM Data Settings

1, 2, 3...

4-6-3 Block Diagram Check

The ITEM data for a specified function block can be read from a Loop Controller
and displayed.
1. Select a function block that has been pasted.
2. Click the right mouse button to display the pop-up menu and select Monitor/
ITEM List. The following dialog box will be display and the ITEM data can be
monitored.
It is also possible to change a single ITEM's data and download that ITEM's data
to the Loop Controller, but only operation data (Type O in the ITEM List) can be
downloaded this way.
1. Double-click the ITEM that you want to change. A setting dialog box like the
one in the following diagram will be displayed.
2. Change the data to the desired value and click the Transfer to LC Button.
The changed value will be displayed in the ITEM List.
This section provides information on how to check the block diagrams connect-
ing the function blocks of a Loop Controller. The following data on the function
blocks, excluding step ladder programs, will be displayed or set.
• Display of analog signal values
• Forced change of analog output signals
• Stop block operation/Cancel stop command for each function block
Section 4-6
271