Inserting User-Defined Blocks - Omron CX-PROCESS TOOL V5.2 - 12-2009 Operation Manual

Creating User-defined Blocks

3-6-4 Inserting User-defined Blocks

1, 2, 3...
When the connection is made, the following Input/Output Setting Dialog Box
will be displayed.
Input some text for the comment, e.g., "PV."
In the same way, connect another spot on the right side of the input interface
block to the input (X1) of the Lead/Delay (Block Model 147). Input some text
for the comment, e.g., "DIST."
Setting the Output Interface
Connect the analog outputs to be output from the user-defined function
block to the output interface block. In this example, the MV input from the
Advanced PID (Block Model 012) block is connected to the left of the output
interface block. A comment, such as "MV" can be input.
6. The results is shown below.
Input interface: PV and DIST
1. Place the cursor in the block diagram where the user-defined block is to be
inserted, right-click, and select Register – User-defined Block – Insert
User-defined Block. As shown below, the block will be inserted as a single
Section
Output interface: MV
3-6
177