Omron CX-PROCESS TOOL V5.2 - 12-2009 Operation Manual page 67

Basic Operating Procedures
Using CX-Process Monitor (Supported Only for Loop Control nits)
5. Set the software connections between function blocks with analog and ac-
cumulator signals (using Edit – Block Diagram from the Settings Menu).
6. Set the ITEMs in all function blocks (and set user link tables or create se-
quence tables or step ladder programs as needed).
Note a) User link tables are supported by LCBjjs only.
b) Sequence tables are supported by LCB05 and LCB05D (LCB ele-
ments 00-LCB05 and 00-LCB05D) only.
7. Go to step 8 in one of the following sections.
Note (1) For details on editing block diagrams, refer to 3-1-8 Editing Block Diagrams.
(2) For details on editing function block ITEMs, refer to 3-1-9 Editing Function
Block ITEMs.
8.Set the function block for data exchange with CX-Process Monitor, i.e., the
Block Send Terminal to Computer Function Blocks.
9.Create the monitor tag file (using Tag Settings – Monitor Tag from the Set-
tings Menu).
10.Create the monitor tag file (using Create Tag File – Monitor Tag from the
Execution Menu).
Section 1-7
39