Omron CX-PROCESS TOOL V5.2 - 12-2009 Operation Manual page 312

Operation Check
1, 2, 3...
CX-Process Tool
Loop Controller
Sequence table
Step number
Rule
286
Operation will continue with the edited sequence table.
Operation for Online Sequence Table Editing
1. The Loop Controller will continue to operate during online editing from the
CX-Process Tool.
2. When editing has been completed, the sequence table is downloaded to the
Loop Controller. While the sequence table is being written to download it,
the Loop Controller will operate with the previous sequence table.
3. When the sequence table in the Loop Controller has been completed down-
loaded, operation for the sequence table will continued from the step num-
ber from before the download. (See note.)
Note If, however, the conditions have been met to move to the next step,
operation will be continued from the next step.
Editing
Start of online
editing
Operating
Note Operation continues with the sequence
table from before the download.
Outputs
The operation of outputs after the download will be as shown in the following
table according to the output status just before the download.
End of online
editing
Downloading
Writing
Download completed.
Continues
Operating
See note.
Execution continues from the
rule being executed in N.
Section 4-6
Time