Installing Finsgateway - Omron CX-PROCESS TOOL V5.2 - 12-2009 Operation Manual

Installing and Uninstalling the Software

2-1-5 Installing FinsGateway

Preparations before Installing FinsGateway
56
11. The following dialog box will be displayed when the Installer completes the
installation. Click the Finish Button.
Note It might be necessary to restart Windows after completing the installation. If nec-
essary, restart Windows according to the message from the Installer.
12. The Readme.txt file will be displayed after the computer is restarted.
13. The Online Registration Dialog Box will be displayed when the Readme.txt
file is closed.
A wizard will be started and will connect to the OMRON CX-One Web if the
Register Button is clicked. (See notes.)
Note a) If the Exit Button is clicked to cancel registration, the Online Reg-
istration Dialog Box will be displayed every time the CX-One Con-
figuration Tool is started.
b) Online installation will not be possible if the computer is not con-
nected to the Internet. Enter the required information on the regis-
tration card and mail it in.
This completes installation of the CX-Programmer.
One of the following communications drivers must be installed in the computer to
enable using the CX-Process Tool.
• CX-Server (Installed at the same time as the CX-Process Tool.)
• FinsGateway Version 3 or higher
FinsGateway Version 3 or FinsGateway 2003 Embedded Version is bundled
with the CX-Process Tool. Install one of the to use FinsGateway as the commu-
nications driver.
The FinsGateway Runtime Version can also be used. If the FinsGateway Run-
time Version is already installed, it is not necessary to install an embedded ver-
sion.
• If FinsGateway Version 2 or lower is already installed, perform Step 1: Backing
Up the FinsGateway Settings first.
Section 2-1