Omron CX-PROCESS TOOL V5.2 - 12-2009 Operation Manual page 303

Operation Check
1, 2, 3... 1. Double-click the function block.
Example
The following Send Dialog Box will appear.
2. Click the Stop Block Operation Button.
3. Change the analog output signal value.
4. Click the Execute Button.
The function block in the block diagram will display the following changes.
• "Stopped" will appear on upper side of the function block.
• The SP has been forcibly changed to 30.00. Therefore, "30.00" will appear
below the SP.
Note The new value must be within the permissible range of the ITEM,
otherwise an error will result and the CX-Process Tool will end the
Section 4-6
277