Omron CX-PROCESS TOOL V5.2 - 12-2009 Operation Manual page 61

Connecting to the PLC
Peripheral Bus
Connections to the Peripheral
Port of the CPU Unit
CX-Process
Tool
IBM PC/AT or
compatible
(9-pin male)
CS1W-CN226 or
CS1W-CN626
Connecting Cable
Connecting through a Controller Link Support Board
Controller Link Unit
Models
The personal computer uses the FinsGateway (Version 2003) Serial Unit Driver
to connect to the PLC's peripheral or RS-232C port via the peripheral bus.
Loop Control Unit
CS1 CPU Unit
Peripheral
port
Note The FinsGateway Serial Unit Driver must be installed to enable connecting the
PLC via Host Link communications.
The personal computer can be connected to the PLC through a Controller Link
Network using the FinsGateway CLK (PCI slot) Driver or a FinsGateway version
2 or higher Controller Link Driver.
CX-Process Tool
(IBM PC/AT or
compatible)
Note The Controller Link Driver (FinsGateway CLK (PCI slot) Driver or the FinsGate-
way version 2 or higher Controller Link Driver) must be installed in order to con-
nect to the PLC via a Controller Link Network.
Controller Link
Unit
CS1W-CLK21-V1
CS1W-CLK23
CS1W-CLK12-V1
CS1W-CLK13
CS1W-CLK52-V1
CS1W-CLK53
CJ1W-CLK21-V1
CJ1W-CLK23
Connections to the RS-232C port of the CPU
Unit or Serial Communications Board or Unit
CX-Process
Loop Control Unit
Tool
IBM PC/AT or
compatible
(9-pin male)
XW2Z-200S-CV
Connecting Cable
Loop Control Unit
Controller Controller
Link Unit Link Unit
Controller Link Support Board
PLC Unit
CS CPU Bus Unit
Series
CJ CPU Bus Unit
Series
Section
CS1 CPU Unit
RS-232C Port
Loop Control Unit
Controller Link Network
Type Transmission
path
Wired Twisted-pair cable
Optical H-PCF Optical
fiber cable
Optical GI Optical fiber
cable
Wired Twisted-pair cable
1-6
33