Omron CX-PROCESS TOOL V5.2 - 12-2009 Operation Manual page 102

Overview of User Interface
Menu Submenu/
Command
Settings, Insert
continued
Delete
Edit
Insert Creates and inserts a function block file (.ist) into the
Node Project Workspace.
Note If the current function block file has been changed, it
must be saved before executing this command.
Insert Creates and inserts an LCU or LCB element into a
LCB/LCU function block file.
The LCU/LCB numbers and corresponding model
numbers are as follows:
00-LCB01:
00-LCB03:
00-LCB05:
00-LCB05D: LCB05D Ver. 1.0 or later
01-LC001:
02-LC001:
03-LC001:
Insert Inserts a block diagram.
Block
Diagram
Insert Creates and adds a function block.
Function
Block
When the current function block file or LCU/LCB element
is selected: Deletes the function block file.
When a function block is selected: Deletes the selected
function block.
Edit Edits function block ITEMs.
Function
Block
ITEMs
Edit Block Sets the CX-Process Tool to Edit Block Diagram Mode
Diagram and make the software connection between function
blocks. The edit block diagram menu will be explained
later.
Edit Step Sets the CX-Process Tool to Edit Step Ladder Program
Ladder Mode and edits the instructions in a Step Ladder Program
Program Block (block model 301). The Edit Step Ladder Program
Menu will be explained later.
Edit Se- Edits a sequence table (Block Model 302). Editing a
quence sequence table must be enabled after double-clicking on
Table the editing screen before this command can be used.
(LCB05
or
LCB05D
only)
Edit User Edits a user link table.
Link
Table
Description
LCB01 Ver. 1.0 or later
LCB03 Ver. 2.0 or later
LCB05 Ver. 1.0 or later
CS1W-LC001
CS1W-LC001
CS1W-LC001
Section 2-2
Conditions for
selection
When the Project
Workspace is
selected
When a function
block file is selected
When an LCU or
LCB element is
selected
When a function
block group is
selected
When a function
block file, LCU/LCB
element, block
diagram, or function
block is selected
When a function
block is selected
When the block
diagram is selected
When a step ladder
program is selected
When a sequence
table is selected
When a function
block file, LCB
element, function
block group, or a
function block file is
selected
75